MME Nodal Test Configuration

Test Activities

• Capacity Test

• Session Loading Test

• Mobile Node Mobility

• Session Loading With Mobility

• Intra-MME Mobility

• Inter-MME Mobility

• Inter technology Mobility

• Command Mode (Settings available for Start Retries, Idle ODC Timeout))

• Sequencer (Settings available for Start Retries)

Test Options

• Initial Network

• Handoff Protocol UMTS(IuPS over IP),UMTS(IuCS over IP),UMTS(IuCS &IuPS over IP),GPRS, eHRPD, 1xRTT, WiFi

• Handoff Type

• SRVCC Handoff Type

• Perform TAU after Handoff

• TAU Delay

• Periodic TAU When Connected

• Target S1-MME IPSec

• Target S1-U IPSec

• Target S1 IPSec

• Load Control Information IE

• Control Plane SMS (Short Message Service)

• Data Tuning       Manual      Auto

• Data IPSec

• Gn Interface to MME

• Optimized Handoff

• Direct Tunnel

• Round Robin Handover

• HSS Interface

• Ut/Ub

• CSC-4 to Mission Critical CMS

• SGs Interface

• MAP-D

• Log eNodeB Status

• LMA Node Emulation

• PMIPv6 Transport

• X2 Interface

• AP Tunnel Type

• ePDG Node Emulation

• LCS Support

• SGi PtP Tunneling Support

• Fireball

• NTSR

• Emergency PDNs

  • Emergency PDN Index
  • Emergency Attach with IMEI
  • Reattach with GUTI

• 2-Way Live Audio Bridging

  • Enable 2-WAY Live Audio Bridging

CIoT

• CP-CIoT EPS Optimization Supported

• S1-U Data Transfer Supported

  • Use Service Request If Apply

  • Activate S1-U Data Transfer

    • Active After (ms)

• UP-CIoT EPS Optimization Supported

• Suspend Context when Idle

• NB-IOT

• Preferred CIoT
• Send Last Message with RAI
• Enable ROHC
•  ROHC Profile ID
• NB-CIoT Supported on Specific NAS Sessions via TDF

• UMTS Version

• UE Initiates Dedicated Bearers

• SGW Relocation

• S1-MME IPSec

• S1-U IPSec

• S1-IPSec

• SGW/PGW Node Emulation

• Same GTP-C TEID per MN on S11

• MMS Support

• Data Traffic

• External Data

• Vendor Variant

• S3 Interface to MME

• Circuit Switched Fallback

• DTM Support

• S10 Interface to MME

• VoLTE

• SRVCC

• Sv Interface

• I2 Interface

• Nc-ISUP

• ePCF Node Emulation

• Cell Change Mode

• PMIPv6 IPSec

• eMBMS M1/M3 Interfaces

• SWm Interface

• S1-Flex (MME Pooling)

• B-TrunC

• Wifi Offload Node Emulation

• WebRTC

• Init From Target eNodeB

eMBMS

M3 Sessions per eNodeB

• Support Flute
• Delay Factor (ms)

ProSe

• PC3/PC8/Ub

Mobile Subscribers

• Number of Subscribers
• Default Bearers per Session
• Dedicated Bearers per Default
• Number of Low Priority Subscribers
• Use Real SIM Card (One Subscriber)
• Use SIM Server
• Command

Dedicated Bearer Rates and Delays

• Configure Individual Dedicated Bearer Delays

• Bearer Start

• Delay Times
• UE Initiates LTE Deactivation with Message
• Disconnect Dedicated Bearer after Connected
• Disconnect Delay
• TFT Settings
• CDMA TFT Settings
• PDN Connect Delay
• PDN Activation Rate
• PDN Connect After Handover Delay (s)
• PDN Failed Threshold (%)
• Attach Start Delay
• Activation Rate
• Deactivation Rate
• PDP Activation Rate Contexts
• PDP Deactivation Rate Contexts
• Home Address Type
• Bearer IPv6 Pool
• Bearer IPv4 Pool
• UE DHCPV4 IP Address
• MAC Address
• Upstream QCI to DSCP Markings
• QCI Settings
• Control Bearer to DSCP Assignments

• DSCP Settings

• Do Not Attach UEs
• Distribution Settings

WiFi Subscribers

• MPLS

• MAC Address

• IP Address Type

• UE DHCPv4

• UE DHCPv4 via Tunnel

• UE Static IPv6

• UE SLAAC

• UE DHCPv6

• UE DHCPv6 via Tunnel

• UE Graceful Shutdown

• UE Graceful Mobility

• UE Authentication

• UE Mobility Re-authentication

• UE Responds to ARP

• Outer IP Type of Service

• Non-3GPP Access with a 5G Capable UE

• Starting PDU Session ID

• Maintain UE IP after Handover

• Send Router Solicitation after Handoff

• Apply Test Data File to Mobile Subscribers