Landslide Performance Test System – Release 24.3 September 2024
All of the parameter topics for the MME Node test case are listed below:
Mobility None Intra-MME Inter-MME Inter-Tech Command Mode
UE Initiates Dedicated Bearers
SGW/PGW Node Emulation
Gn Interface to SGSN
S10 Interface to MME
S1-U IPSec
SGW Relocation
Control Plane SMS (Short Message Service)
Handoff Protocol UMTS/UMTS (IuPS over IP, IuCs Over IP, IuCS & IuPS over IP), GPRS
Initial Network
HSS Interface
Optimized Handoff
Circuit Switched Fallback
SRVCC
Sv Interface
SGd Interface
eMBMS M3 Interface
LCS Support
B-TrunC
Fireball
NTSR
N26 Interface
Data Traffic
T-ADS Information
Use Bearer parameters from UE
S1-MME IPSec
S3 Interface to SGSN
Target S1-MME IPSec
Target S1-U IPSec
Vendor Variant
UMTS Version
Handoff Type
Piggyback Simulation
I2 Interface
SGs Interface
S102 Interface
APN DNS Lookup
ESMLC Node Emulation
S1-Flex (MME Pooling)
Reset UE Positioning Stored Info
SLg Interface
SGi PtP Tunneling Support
DC Interface
SBc Interface
eMBMS
CIoT
S1-U Data Transfer Supported
Activate S1-U Data Transfer
Active After (ms)
Enable ROHC
UP-CIoT EPS Optimization Supported
Mobile Subscribers
MME Disconnect Bearer after Connected
Disconnect Default Bearer
Disconnect Delay Time (s)
Upstream QCI to DSCP Markings
QCI Settings
© 2024 Spirent Communications Inc. All Rights Reserved.