Landslide provides SG interface to a simulated Mobile Switching Center (MSC) Node in MSC Node and MME Nodal, test cases.
Also used as MSC I2 Node when I2 Interface is used in MME Nodal, MME Node and SGW Nodal. Used in SMS Network test case when emulating an MSC.
Also used as MSC MAP Node when MAP-D Interface is used in MME Nodal.
Define the following:
| MSC Addr |
Enter MSC Address (In MSC I2 Node, MSC MAP Node). Default : @msc.cisited1.net Tcl Parameter : MscNodeAddr Tcl Parameter : MscI2NodeAddr Tcl Parameter : MscMapNodeAddr |
| Multi-Homed |
Select to indicate that SCTP endpoint is multi-homed, where more than one destination transport address is used to reach the endpoint. When SGs is enabled : Consecutive Secondary Node Address - Select to enable for consecutive address for multi-homed capabilities. Two test nodes provides with consecutive IP addresses. Separate Secondary Node Address - Select to enable Separate address that is not consecutive. Enable second node and enter Physical Interface, IP address and Outbound traffic port. Enter the Primary and Secondary Nodes. Tcl Parameter : MscNodeSecAddr Tcl Parameter : MscSctpMultiHomedMultiSrcEn Tcl Parameter : MscSctpMultiHomedSrcSecAddrEn |
| SCTP 2x2 Mesh |
Available when Multi-Homed is enabled. Select to enable SCTP multi-homed 2x2 Mesh capabilities. One SCTP association has 2 multi-homed endpoints (EP1 and EP2), and each of them has 2 IP addresses, one primary address (Pri) and one Secondary address (Sec). Without enabling this parameter the communication paths are: EP1 Pri <==> EP2 Pri, EP1 Sec <==> EP2 Sec (total of 2 paths). After enabling this parameter the communication paths are: EP1 Pri <==> EP2 Pri, EP1 Pri <==> EP2 Sec,, EP1 Sec <===> EP2 Pri. and EP1 Sec <===> EP2 Sec. (total of 4 paths). Tcl Parameter: MscSctpMeshEn |
| MSC Host |
Enter MSC Host (In MSC I2 Node). Default : @msc.cisited1.net Tcl Parameter : MscNodeHost Tcl Parameter : MscI2NodeHost |
| MSC Port |
Enter MSC Port (In MSC I2 Node). Default : 5060 Tcl Parameter : MscNodePort Tcl Parameter : MscI2NodePort |
| UTRAN Cell ID |
Enter UTRAN Cell IDt (In MSC I2 Node). Default : 234151D0FCE11 Tcl Parameter : MscNodeUtranCellId Tcl Parameter : MscI2NodeUtranCellId |
| Visited Network ID |
Enter Visited Network ID (In MSC I2 Node). Default: Visited Network Number 1 Tcl Parameter : MscNodeVisitedNtwId Tcl Parameter : MscI2NodeVisitedNtwId |
| MSISDN |
Used in the SMS Network test case and MME Nodal when MAP-D is enabled. Enter the address of the MSC. Default: 17962490141 Tcl Parameters: MscNodeMsIsdn Tcl Parameters: MscMapNodeMsIsdn |
With an Ethernet User Node, you can define:
The IP address and routing options... The IP Address will increment for each node.
The MAC Address to override the Hardware MAC address so the packets sent out of the interface will use the provisioned MAC address rather the Hardware MAC Address.
Custom port selection... and error injection with the Advanced... button.
The Outbound Traffic Port to disable the normal routing function and to force packets out of the selected interface.
1 Maximum rates, number of sessions, and number of emulated nodes vary depending on the test configuration and the test system's licensed capacity.