eMBMS-GW SGmb Node

In eMBMS Node test case, the eMBMS-GW SGmb Node provides control plane communication with the BM-SC via SGmb interface. It’s based on Diameter protocol.

It’s available in “eMBMS-GW” emulator mode.

Configure the following:

Host: Depending on whether the node emulates originating or destination point, Host identifies the endpoint that originated the Diameter message or the Diameter Identity of the destination host.
Realm: Depending on whether the node emulates originating or destination point, Realm identifies the realm of the originator of any Diameter message or the realm the message is to be routed to.

Ethernet Configuration

With an Ethernet User Node, you can define:

The IP address and routing options... The IP Address (IPv4 or IPv6) will increment for each node.
The MAC Address to override the Hardware MAC address so the packets sent out of the interface will use the provisioned MAC address rather the Hardware MAC Address.
Custom port selection... and error injection with the Advanced... button.
The Outbound Traffic Port to disable the normal routing function and to force packets out of the selected interface.