Setting Up a MIP Revocation Test


When you select a MIP Revocation test, you can when the revocations begin and the rate at which revocation messages are sent.

These instructions assume that you are working with a saved test session, and only provide information on defining this test activity. See Related Topics for instructions on configuring the test cases that can use a MIP Revocation test.

TIP: Start with a test case that you have successfully executed with a Capacity Test.

To set up a MIP Revocation test:

  1. Open a test session...

  2. Edit the test case... that will run the test.

  3. Select the MIP tab and check the Revocation Support Extension... checkbox.

  4. Select the General tab and select MIP Revocation from the Test Activity drop-down list.

  5. Click the Settings... button. A dialog window opens and displays the test activity parameters.

  6. Define the start time for the updates with Revocation Time... and Revocation Start Type... If you begin the revocations When All Sessions Started, you can define the message rate; otherwise the  Activation Rate defines the revocation rate.

  7. Click OK to close the test activity window.

  8. Click OK to apply the test case settings. If you have entered a value outside of the allowable range you will receive an error.


Related Topics

  1. MIP Revocation Settings
  2. Setting Up an IPv4 HA Nodal Test
  3. Setting Up CDMA2000 Mobile IP Tests