WISPR

Configure the WISPr authentication information in WiFi Offload Gateway Node test case when you select  UE Authentication as WISPr on the Emulator Configuration tab.

Authentication Settings

Username/Password

  • User Name

  • Password

  • Retry Test

^ Back to Top


 

User Name/Password Enter the unique user name and password required for authentication.   See User Credentials

Authentication Type

Select the type of authentication performed.

Username/Password

Select to enter the password for WISPR authentication.

Password — Defines the password that is used for authentication. You can provision a unique password for each user name by using an Auto-Increment format.

EAP

Use EAP Authentication to enable EAP authentication support (for Mobile handsets with WISPR authentication). You can configure the EAP methods that will be supported and the acceptable credentials for each method with the EAP Settings window.

Tcl Parameter: WisprAuthType

 

Max Session Time (s)

(WOGW Node TC)

Allows you to configure a timer that will keep the session(s) alive for the specified time.

Range: 0 - 65535

Default: 7200

Tcl Parameter: WisprMaxSessionTime

Authentication Port

(WOGW Nodal TC)

 

Enter the UDP port used for WISPr authentication.

Retry

Select to verify the login request (the User Name and Password entered.

In WiFi Offload Gateway Nodal test case, the Request Timeout (s) and Attempts are available for configuratrion. When you select Retry selected, your initial login request is ignored and verified the number of times entered in Attempts.  

Request Timeout: Is the length of time to wait without a response (re-entering your credentials).

Attempts: Indicates the number of times to verify request for login.

When you do not select Retry, the login attempt occurs only once.

Polling Test

(WOGW Node TC)

 

Select to Poll the authentication status and enter the frequency of Poll. That is, enter the Polling Delay in seconds to indicate the time to wait before polling the status again.

Type: True/False

Default: False

Tcl Parameter: WisprPollingTestEn

Polling Delay

Option: 0 - 255

Default: 1

Tcl Parameter: WisprPollingDelay

 

 

 

 

^ Back to Top