M3 mme tab

The M3-AP tab is used to define the re-connection (between eNodeB and MME) and response time.

MME parameters

Version
Setup Time
Response Time
Total Number of Service Areas
Starting Service area
Number of Service Areas per Node

MCE Configuration Update

Enable MCE Configuration Updates
Update Total Number of Service Areas
Update Starting Service Area
Update Number of Service Areas per Node

Update Interval (ms)

Related Measurements

Measurements collected for M3-AP related processing are reported on the M3-AP report tabs.

Version

Select the proprietary version of the application from the dropdown list.

Options: 9.4.0, 11.6.0 (Custom Multiple Choice ValuesCustom Multiple Choice Values)

Values:

8.5.1 : 0	8.10.0 : 5	9.8.0 : 10
8.6.1 : 1	9.4.0 : 6	10.5.0 : 11
8.7.0 : 2	9.5.0 : 7	10.6.0 : 12
8.8.0 : 3	9.6.0 : 8	11.1.0 : 13
8.9.0 : 4	9.7.0 : 9

Default: 11.6.0

Tcl Parameters: M3ApVersion

Setup Time

This defines the reconnect delay time if initial connection fails (applies to 3GPP only).

Tcl Parameters: M3ApSetupTime

Response Time

Indicates the length of time the Landslide waits for a response to an M3AP request message.

NOTE: An M3 AP request message will not be resent when the M3AP Response Timer expires.

Tcl Parameters: M3ApResponsetime

Total Number of Service Areas

Input the total number of service areas.

Tcl Parameters: M3ApNumServiceArea

Option: 1 - 65535

Default: 1

Starting Service Area

Input the starting service area.

Option: 1 - 65535

Default: 1

Tcl Parameters: M3ApStartServiceArea

Number of Service Area per Node

Input the service area per node.

Option: 1 - 4000

Default: 1

Tcl Parameters: M3ApServiceAreaPerNode

MCE Configuration Update

The MCE Configuration Update procedure updates application level configuration data needed for the eNodeB and MME inter-operation on the M3 interface. The eNodeB initiates the update procedure by sending an M3 CONFIGURATION UPDATE message to the MME with the appropriate configuration parameters/data.

Enable M3 Configuration Update Delay

Select to enable/configure parameters to be included in the eNodeB Configuration Update message.

Default False

Tcl Parameter: M3ApMceConfigUpdateDelayEn

NOTE: When you enable M3 Configuration Update, you must select and provide following parameters:

§ Update Total Number if Service Areas

§ Update Starting Service Area

§ Update Number of Service Areas per Node

Set M3 Configuration Update Delay

Tcl Parameter: M3ApMceConfigUpdateDelay

Option: 1 - 65535

Default: 10

Update Total Number of Service Areas

Input the updated total number of service areas.

Tcl Parameter: M3ApUpdateNumServiceArea

Option: 1 - 65535

Default: 1

Update Starting Service Area

Input the updated starting service area.

Option: 1 - 65535

Default: 1

Tcl Parameter: M3ApUpdateStartServiceArea

Update Number of Service Area per Node

Input the updated service area per node.

Option: 1 - 4000

Default: 1

Tcl Parameter: M3ApUpdateServiceAreasPerNode