E2 Ap Tab
The E2-AP defines the general protocol by which the nRT-RIC and Nodes communicate. The interface that is designed for communication between DU/CU and Near-Real Time RIC is called E2. The protocol for the communication over E2 interface is called E2AP.
The E2-AP tab is available in RIC Node and RIC Nodal Test Cases.
Related Measurements
Measurements collected for E2AP related processing are reported on the E2AP Measurements tab.
| RIC Service Update Delay (s) |
Select to enter the RIC Service Update Delay in seconds
Available in RIC Nodal test case.
Range : 1 to 65535
Default : 1
Tcl Parameters: E2apRicSvcUpdDelayEn
Tcl Parameters: E2apRicSvcUpdDelay
|
| E2 Node Configuration Update Delay (s) |
Select to enter the E2 Node Configuration Update Delay in seconds
Available in RIC Nodal test case.
Range : 1 to 65535
Default : 1
Tcl Parameters: E2apE2NodeCfgUpdUpdDelayEn
Tcl Parameters: E2apE2NodeCfgUpdDelay
|
| RIC Service Query Delay (s) |
Select to enter the RIC Service Query Delay in seconds
Available in RIC Node test case.
Range : 1 to 65535
Default : 1
Tcl Parameters: E2apRicSvcQueryDelayEn
Tcl Parameters: E2apRicSvcQueryDelay
|
| Reset |
Select for Reset procedure.
Available in both RIC Nodal and RIC Node test cases.
Tcl Parameter: E2apResetEn
|
^ Back to Top